07. Cut end pieces

Measure your mark

Grab the panel you are going to cut and place it against the side wall and the last piece you placed. 

Mark a line on the top of your piece where you will make your cut.

Make your cut

Using your square or straight edge, align to the mark you made. Use your utility knife and cut on your line 2-3 times.

Be sure to make your cuts on the front of your panel for the cleanest cut.

 

Snap your panel

Turn the panel over and placing one hand near the cut, bend the panel inward until you feel the SNAP! 

Bend the panel back the other way to tear the adhesive. Use your utility to cut through the tape if necessary.

Test the fit

Before removing the backing from the tape, dry fit the panel in to make sure it will fit nice and snug.

Place your piece

Peel off the backing and place your piece on the wall ensuring that it is level with the panel next to it.